I have a 2016 Charger scat pack, supercharger, headers, cam, forded pistons. On the dyno it made 551 ft/lbs torque. I know on the uconnect torque screen i will not read above a certain value, i have the tazer and even with the hellcat gauges on the graph goes to 800, but still will not read above the stock value. So mess around with the scanner today. I was logging actual torque, i noticed that the actaul torque will not go above 460 and stay flat the whole run. Even at 50% throttle I am at 460, floor it and it doesn't move. Is this normal? is it the same as the uconnect? And would that effect the tune. Just curious.