-
Tuner in Training
going mafless tranny ?'s
was going to try to go mafless and cant figure out how the MAf ties into the transmission. I thought 98's shifted off speed and rpm. Anyone know how it ties in i had heard it has to do with load Thanks Scott
-
Senior Tuner
Re: going mafless tranny ?'s
I believe shiftpoints are just MPH, TPS, RPM but
the transmission pressure modulation is run off
the "torque" calculation, which probably has MAF
(or airflow, perhaps derived off the speed-density
mode in absence of the MAF) in there. But as to
how the torque computation is affected... I guess
the best bet would be to unhook the MAF, and log
the Delivered Torque - Engine and -Transmission
PIDs and see if you still get sane values when you
force it into speed density operation.
-
HP Tuners Owner
Re: going mafless tranny ?'s
in some calibrations MAF failure will also trigger line pressure increases. This is usually earlier code.