Results 1 to 5 of 5

Thread: prolink+ 0-5v sensor

  1. #1
    Tuner
    Join Date
    Sep 2023
    Location
    Bay Area, CA
    Posts
    62

    prolink+ 0-5v sensor

    I am trying to setup a fuel pressure and oil pressure gauge through the two prolink analog inputs, using 0-5v, 0-100psi transducers.

    If I am understanding this correctly;

    Connect signal wires from transducers to prolink
    Connect ground wires from transducers to prolink
    Connect 12v (ignition on) to transducers
    Following the hpt directions for transforming voltage into sensor data.

    I dont like doing wiring twice so just wanted to nail down a procedure before attempting, so any tips would be helpful. Thanks

  2. #2
    Tuning Addict
    Join Date
    Apr 2017
    Posts
    10,887
    Your transducers are designed for 12V in and 5V out?
    Quote Originally Posted by SiriusC1024 View Post
    I think they're junkyard rebuilds.

  3. #3
    Tuner
    Join Date
    Sep 2023
    Location
    Bay Area, CA
    Posts
    62
    ahh no lol. Where would I get 5v from to send to the sensor?

  4. #4
    Tuning Addict
    Join Date
    Apr 2017
    Posts
    10,887
    Any of the 5V wires already going to any of the original 3-wire sensors on the vehicle?
    Quote Originally Posted by SiriusC1024 View Post
    I think they're junkyard rebuilds.

  5. #5
    Tuner
    Join Date
    Sep 2023
    Location
    Bay Area, CA
    Posts
    62
    roger thanks