This is my VE table and it had a % there, and when I clicked to scroll through the options for it, I got a blank...how do I get the percent back?
Screenshot 2025-05-21 170729.jpg
This is my VE table and it had a % there, and when I clicked to scroll through the options for it, I got a blank...how do I get the percent back?
Screenshot 2025-05-21 170729.jpg
Right click > Units.
Originally Posted by SiriusC1024
blindsquirrel...ok, got it.
What do the #'s represent? As in, I am trying to make a vcm scanner table and cannot figure out what the units are to be used. I got both axis copied from the VE table.
https://forum.hptuners.com/showthrea...ll=1#post14397
You can open a support ticket here https://support.hptuners.com/
So could I use lambda in the cells and take the reading and divide by the lambda I want and then use that as a multiplier in VE table?
Units in the table don't matter, the error collected in the scanner applies the same whether the VE table is showing Number or Percent or Quatloos or Dunecats*.
*I can post the image again if it'll help
Reply With Quote